[. . . ] The manufacturer normally supplies the appliance with the temperature on an intermediate setting, so you simply have to connect the appliance. NOTE: if no temperature is displayed when you connect the appliance, press button (1) to turn on the freezer compartment. The appliance`s electronic memory stores the control panel settings when you turn off the appliance, so you simply have to press button (1) to turn the freezer compartment on again. [. . . ] NOTE: If the appliance is turned off for a long time or is switched on for the first time, the red light will come on until the freezer temperature decreases. Keep pressing button (2) so that all LEDs come on with a bright light and press the button again until the orange light comes on. This mode powers the compressor of the freezer compartment continually for a maximum of 50 hours, for quick freezing. press button (3) to stop Super mode , before the end of the 50-hour period. NOTE: If the compressor is not operating when you select SUPER mode, the system will watt for the compressor to work before starling SUPER mode. If you want considerably faster freezing times, you can also remove the box. Freezing takes 24 hours and you can then put the box back and arrange the foods in the freezer. After 50 hours the electronic memory board will automatically reset the temperature to the previous intermediate setting. The maximum quantities of food that you can freeze are indicated on the rating plate (see figure 2). Remove all boxes apart from the bottom one for freezing and storage standards` tests. (Figure 2) The fridge compartment is automatically defrosted when the compressor is not working. A small amount of frost or drops of water on the back of the fridge compartment when the fridge is working is normal. We recommend you defrost the freezer compartment when the frost is more than 3 mm thick. If you need to contact our Service Department in the event of faults, remember to give them the information on the plate. [. . . ] To make sure the fridge-freezer works properly, air must circulate to cool the condenser which is situated at the bottom of the appliance. The unit must have a rear outlet with top opening that is not obstructed and a front opening which is covered by the ventilation grid. Fit the appliance door to the door of the unit, using the slots on the slide bracket as a guide. [. . . ]